Waves Parametric Convolution Reverb IR-360 Manual do Utilizador descarregar pdf (Página 5)

Controls and Displays

CONTROLS

TIME: 0.10 – 20.00sec. Default: 2.00

Reverb time in seconds, defines how many seconds it will take any sound to

decay by 60dB (RT

ET/DRY: 0=Dry,100=Wet. Default:100.

This controls the balance between the Dry input signal and the generated Reverb

signal. In Send scenarios it is common to use the fully wet output.

Reverb Damping Controls

The Reverb Damping controls define longer or shorter decay for the Hi or Low

Frequencies in relation to the main Reverb Time.

OW DAMP FREQ: 16 – 1600Hz. Default:160Hz

Defines the frequency below which the Reverb time is controlled by the Low

Damping Ratio Control .

OW DAMPING RATIO: 0.10 – 2.00. Default :1.10

Defines the ratio by which the frequencies below the Low Damp Frequency will

decay in relation to the general Reverb Time. Values less than 1.00 are shorter,

and values greater than 1.00 are longer than the general Reverb Time.

I DAMP FREQ: 1000 – 21000Hz. Default: 2625Hz

Defines the frequency above which the Reverb time is controlled by the Hi

Damping Ration Control.

I DAMPING RATIO: 0.10 – 2.00. Default: 1.10

Defines the ratio by which the frequencies above the Hi Damp Frequency will

decay in relation to the general Reverb Time. Values less than 1.00 are shorter,

and values greater than 1.00 are longer than the general Reverb Time.

Waves R360 software guide page 5 of 8

1 2 3 4 5 6 7 8

Sem comentários

Waves Parametric Convolution Reverb IR-360 Manual do Utilizador Página 5